Precautions for foundation fixation and installation of lawn mosquito-killing lamp

All kinds of lawn mosquito-killing lamps can be seen in urban green belts, lawns and parks. From the shape, it can be seen that the general lawn lamp is either installed close to the ground or tens of centimeters higher than the ground. However, no matter how in the actual installation, the foundation of the lawn mosquito-killing lamp must be completed. To be exact, the installation can be stable and the later work can be better carried out. So what aspects should be taken into account when fixing and installing the foundation of lawn mosquito control lamp? What should I pay attention to?

Note: The lawn mosquito control lamp has solar mosquito control lamp and AC mosquito control lamp. Among them, the solar mosquito killer lamp is very convenient to install. Today, we are talking about the precautions for the foundation fixation and installation of AC lawn mosquito killer lamp.

1. Embed the power pipeline in advance

The AC lawn mosquito-killing lamp needs to be connected with 220V power supply, so the first point of the foundation of the lawn mosquito-killing lamp is to bury the pipeline in advance, which seems to be nonsense. But there are really some people who have not done well, which will cause great trouble to the later construction. Because it is buried in the ground, in addition to the zero line and the fire line of the lawn mosquito-killing lamp, we must also remember to bury the ground wire to prevent hidden dangers in the future. It is suggested that the wires that leak out of the ground must be properly insulated and protected, such as using special threading pipes.

2. When pouring the foundation, remember to lead out the buried wires

When pouring the foundation of lawn mosquito-killing lamp, it is usually dug down by 20 cm or even 40 cm, then the embedded management line is led out, and then poured in cement until it is completely dry. The embedded pipeline must be at the center of the whole concrete pouring. At the same time, the pipeline must be sleeved with protective pipe. To play a protective role. In the later stage, when the lamps are installed, they are fixed on the pouring surface by expansion screws.

3. The size of the foundation is determined according to the environment and geological conditions

Before pouring the foundation of lawn mosquito-killing lamp, the method to fix the lamp should be determined according to the environment and geology. Corresponding to the expansion screw fixation method, there is also the anchor bolt fixation method. According to the spacing of the fixing screw holes of the lamps, the anchor bolts shall be embedded in the cement in advance. After the cement is thoroughly dried, the lamps shall be connected to the power line and then the lawn mosquito control lamp shall be fixed. After the lamp holder of the lawn mosquito control lamp is fixed on the bolt, the screws shall be screwed on and completely fixed. The trouble with this fixing method is that once the fixing position of the anchor bolt is wrong or the bolt is deformed, it will cause great trouble for the fixing of the lawn mosquito-killing lamp.

For fixing the foundation of AC lawn mosquito-killing lamp, it is necessary to consider the embedding of electric wires in advance, and determine the method to complete the foundation pouring according to the environmental reasons.

Warm prompt for the selection of outdoor mosquito control lamp: AC mosquito control lamp needs external power supply and cement pouring, so Suntech suggests that if it is in the project planning or construction stage, AC mosquito control lamp can be selected, because it can be installed in a unified wiring trench. If it is a built environment, it is recommended to use solar mosquito control lamp, which is more convenient to install and use.